Напечатал дракона

I really liked the style of the dragon done here https://www.thingiverse.com/thing:570345 by muzz64 and thought I would try my hand at making it flexi with both wings attaching with only pressure. The wings attached for me great and are very hard to take back out. I'm sure results will vary dependent on how well printers are setup.(I have some elephant foot on my prints which may be helping the fit). Try one wing and if it is too loose try printing at 101%. Update: Rev B Changes Improved the clips to attach the wings, They will be a little harder to get in but should be very hard to take out.(RevB not compatible with the first Dragon)I have not been able to remove the wings with out breaking something. Improved the arch of the neck, his head should not point down as much. This may differ from printer to printer. Increased the size of the hinges on the wings. This should make them more robust.

Easy print of a dragon with wings. This is the dragon equivalent of the popular MakerBot Mr. Jawz print. Square section so it prints flat on a raft. Note: The orange dragon pictured is the final version. It has an additional spike on the top of its head compared to the green one. If you like this take time to check out my other designs! Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to [email protected] and, to those who do, thanks in advance!