BLOODBORNE PC Remaster стабильные100 фпс на 2к

Мод нужно скинуть в директорию dvdroot_ps4 с заменой файлов, ниже скрин патчей в shadPS4

Чтобы не вылетало и работало стабильно нужно настроить shadPS4 -

shadps4 recommended settings:in the shadps4qtlauncher, right click on bloodborne and hit "game-specific settings" and under experimental turn on

Enable Devkit Console Mode (required for enabling the Increased Graphics Heap Sizes in the patch menu)

Enable Direct Memory Access (test this on or off, as for me it helped with some artifacting)

Enable Shader Cache (not mod specific, but just good to turn on in general)

Additional DMem Allocation (I have it set to 5000MB, but play around with whatever value stops things from rendering because of my high res textures which do eat up more memory)

In the shadps4 patch menu, I recommend enablingModel LOD -2 (Highest)Skip Intro (unless you want the intro of course)Increased Graphics Heap Sizes (required for higher resolutions)Choose a Light Grid patch that matches your monitor's resolution, so for me I choose 1440p Light GridAnd then you can choose a resolution patch if you don't want to play at the default 1080p. I play at 1440p.You can also use a 60fps patch if your rig can handle it. Mine can depending on the situation at 1440p, but it's still not consistent enough for me, as you get higher input latency across the board even if you maintain 60fps. The default 30fps cap has very low input latency, but not everyone is super sensitive to it, understandably.KNOWN ISSUES:old yharnam has these pillars that are either too bright or too dark (still looking into)